Klüberplex AG 11-462 White operating and priming lubricant 5kg

Klüberplex AG 11-461 and 462 offer very good wear and corrosion protective properties contributing to an efficient operation of your highly loaded installations and components.
These adhesive greases have proven effective for many years, providing reliable protection of components also when exposed to salt water or during extended periods of standstill.

• Volume: 5 kg bucket
• Available in 450 g cartridge, 400 ml spray can, 1kg can, 25kg bucket

Your benefits at a glance

• Reduced maintenance needs
  • low contamination of machine environment due to use of white solid lubricants and low lubricant consumption
  • very good adhesion even at low temperatures
  • product streamlining possible as the product is suitable for gear rim / pinion drives and bearings
• Improved component performance
  • less wear due to selected solid lubricants and additives
  • very good corrosion protection also when exposed to salt water

Application
Klüberplex AG 11-461 and 462 have been designed as priming lubricants for gear rim and pinion drives and can also be used as contrast lubricant for checking the drive’s load pattern.
In the offshore sector, marine applications and wind power stations subject to salt water, open gears, low-speed rolling bearings, sliding and guide rails, steel cables of winches or cranes and similar components can be effectively lubricated and protected using Klüberplex AG 11-461 and 462.

Application notes:

Priming lubrication
Klüberplex AG 11-461 and 462 are applied by brush or spatula.
For optimum results, we recommend cleaning the surfaces to be lubricated prior to lubrication.
To determine the right quantity for your application, the diagram overleaf provides guide values.

Operational lubrication
Klüberplex AG 11-461 and 462 can be applied by manually operated grease guns or through appropriate central lubricating systems and are sprayable at temperatures down to 0 °C.
When applied by spray, an exhaustion device is necessary in order to avoid inhalation of spray mist (see SDS point 2).
Provided sufficient relubrication is ensured, short-term thermal loads of up to 200°C are permissible.The lubricant quantities to be used depend on the operating conditions and must be determined for each application individually. Extended exposure to intense sunlight may slightly change the lubricant’s surface color without affecting its performance.

Product data:

Article number	039091
Solid lubricants, percentage	approx. 20 % by weight
Lower service temperature	-10 °C / 14 °F
Upper service temperature	150 °C / 302 °F
Color space	white
Texture	homogeneous
Density at 20 °C	approx. 1.05 g/cm³
NLGI grade, DIN 51818	2
Worked penetration, DIN ISO 2137, 25 °C, lower limit value	265 x 0.1 mm
Worked penetration, DIN ISO 2137, 25 °C, upper limit value	295 x 0.1 mm
ISO viscosity grade of the base oil, DIN ISO 3448	460
Drop point, DIN ISO 2176, IP 396	>= 180 °C
FZG scuffing test, based on DIN ISO 14635, A/2,76/room temperature, scuffing load stage	>= 12
Functional lubricant film	approx. -40 °C
Water resistance, DIN 51807 pt. 01, 3 h/90 °C, rating	0 – 90
Minimum shelf life from the date of manufacture – in a dry, frostfree place and in the unopened  original container, approx.	24 months

Information on product safety (Manufacturer, Contact)

KLÜBER LUBRICATION MÜNCHEN GMBH & CO. KG, Geisenhausenerstraße 7, 81379 München, GERMANY, +49 89 7876 0, [email protected], www.klueber.com