Migma Rino PGG

Application:

Jokisch Migma Rino PGG is a frost and corrosion protection medium suitable according to VDI guideline 2035.
It can be used in all technical areas, such as heat pumps, geothermal systems, air conditioning, heat recovery systems, and heating and cooling systems.
Before initial filling, the system must be thoroughly cleaned. In systems using steel, flushing is required to remove flash rust. A suitable filter should be installed in each solar system. A mesh width of 50–80 µm is recommended.

Properties:

Yellow, odorless liquid based on monoethylene glycol for use as a heat transfer medium with highly effective corrosion protection additives and hardness stabilizers.
The inhibitor system protects commonly used metal materials against corrosion and deposits.
Even the use of galvanized components is possible. The zinc coating may dissolve over time but does not affect the fluid’s performance. The new additive formula prevents flocculation and residue formation.

Recommended Concentration:

Mixable with water in any ratio. Do not fall below 20% concentration to ensure corrosion protection.
Jokisch Migma Rino PGG should only be used with water hardness up to 20 °dH. Ideally, use fully demineralized water.

• Heat pumps and geothermal systems: 25–35 vol.%
• Air conditioning and heat recovery systems: 35–40 vol.%
• Pure frost protection: 35–40 vol.%

Safety data sheet available upon request.
Hazard classification: Acute Tox. 4, STOT RE 2